911 Turbo
The bearing housing is inserted into the crankcase of the Boxster engine
The water closure caps are pressed into the Boxster engine
The camshaft of the Boxster engine is screwed into place
Assembly of the wiring harness in the Boxster engine
Removing the interior of the 911 Turbo
Marriage in car production: the engine is installed
Marriage in car production: the engine is installed
The underbody cover is installed on the 911 Turbo
Assembly of the 911 Turbo front end
The wheels are mounted on the 911 Carrera
The wheels are mounted on the 911 Carrera
During the fitting of pre-assembled doors, a handling device bears the main load
The cockpit is prepared for installation on a separate assembly belt
Boxster S in the "seat assembly" production phase
All vehicles are checked for leaks in a rain test
All vehicles are checked for leaks in a rain test
Before the cars leave production, the paintwork is checked again in the light tunnel
Side section production of the 911 Turbo
Before the floorpan and the side sections are welded together, they are connected loosely in the clip station
